Svenska Not logged in: Log in | Register

2015-03-17:

Note: Text covers an earlier version.

Approving and Disqualifying Competitors

Updated: 2015-03-17

Handle manual corrections of punches and result on the page Competitors. If you want to approve a runner missing punches, you need to add the missing punches manually, see Editing Punches.

When you select a competitor, the readout punches shows together with the expected course. Extra punches, that is, punches that could not be matched against the course, are shown at the bottom. A missing punch is shown as a gap.

The competitors running time is controlled by the fields Start time and Finish time. If you manually want to set the running time, you have to adjust these fields accordingly. The start and finish time are controlled by the start punch and finish punch.
MeOS Insight
If there is a card with a finish punch, it is not possible to directly assign another finish time. Instead, you have to edit the finish punch. The same rule applies to the start punch. The start time can also be determined by the class or by the time for changeover, in case of a relay.
The status shows if the competitor is approved, has a missing punch, is disqualified, etc. The following states are possible: Unknown (–), Valid Result (OK), Did Not Start (DNS), Missing Punch (MP), Did Not Finish (DNF), Disqualified (DISQ), and Over Maximum Time (OMT). In addition, there is a status Not Taking Part (NTP). This means that the runner is filtered away from practically all lists. In a competition with several stages, you can use this status for a runner not taking part in a particular stage.

If there is a card, it controls the status to some extent. In most cases you don't need to edit the card, see the section Controls for instructions how to mark a control as out of order.
To post a comment, you need to log in.