MeOS 4.0 English MeOS 4.0 Swedish MeOS 3.9 English MeOS 3.9 Swedish MeOS 3.8 English MeOS 3.8 Swedish MeOS 3.7 English MeOS 3.7 Swedish MeOS 3.6 English MeOS 3.6 Swedish MeOS 3.5 English MeOS 3.5 Swedish MeOS 3.4 English MeOS 3.4 Swedish MeOS 3.3 English MeOS 3.3 Swedish MeOS 3.2 English MeOS 3.2 Swedish MeOS 3.1 English MeOS 3.1 Swedish MeOS 3.0 English MeOS 3.0 Swedish MeOS 2.5 Swedish

2014-03-21:

Note: Text covers an earlier version.

Controls

Updated: 2014-03-21

In most cases, MeOS handles controls automatically for you, but you can make certain manual settings. On the page Controls you can see all used controls. Every control has a unique id number. Normally, this number is the same as the punching code, but the punching code can be changed if needed. You may assign a Name to each or some controls. This name is used in the Speaker Module, and you can also print result lists with splits at named controls. Status defines how a control is used. Possible values are OK, Multiple, Rogaining, or Bad.

• OK means that the control is operating normally; a competitor has passed the control if one of the specified punch codes has been registered. Several punch codes can be specified to accomplish simple forking or to replace a non-functional control.
• Multiple means that the competitor need to register all specified punch codes to pass the control. This functionality can be used to create a nest of controls that can be taken in any order.
• Bad means that the control is not used at all; the result is that same is if the control was removed from all courses.
• Rogaining is described in the section Rogaining.
• No timing means that MeOS ignores the time on the leg to the control (from the previous control) when times are calculated. The effect is that the punching time on the control is the same as the punching time on the previous control, and that the total running time is independent of the actual time on the leg to this control.

Time adjustment is used when the time in the control is wrong; write a time adjustment using the format +/- MM:SS.

Minimum leg time means that no runner can get a time on the leg that is faster than the specified time. If the runner is faster, the all following times are adjusted. This can be use to cross a road with traffic without time pressure. Note that the time adjustment cannot be done until after the runner has finished, so radio times can be somewhat wrong when this functionality is in use.

Contents

1. Using the Same Radio Control Several Times
2. Table Mode and Statistics